Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] Connecting mounting hole with Grounding

Status
Not open for further replies.
V

venkates2218

Full Member level 6
Joined
Sep 30, 2016
Messages
354
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,298
Activity points
4,306
image_!.png

I tried to connect the ground wire for board with mounting hole in the PCB.But while pouring ground copper,it not connecting with mounting holes pad.

How to connect the copper pour with mounting holes..?
 

You did not specify what CAD is using, but as a rule, these drills are created in the schematic scope (eg, a component composed only of a huge Via), and you ground it there, so that these holes will now be treated such as any other components which need to be routed.
 

andre_teprom said:
You did not specify what CAD is using, but as a rule, these drills are created in the schematic scope (eg, a component composed only of a huge Via), and you ground it there, so that these holes will now be treated such as any other components which need to be routed.
Click to expand...

Sorry I'm using Eagle PCB
 

Hi,

where do this "mounting holes" come from?
Is it a device from a library?
--> then you need to open the SCHEMATIC and connect the symbol pin to the GND Signal
if there is no symbol, then you need to modify the library


If you did just add a VIA, then you need to connect the via with the GND Signal.

Klaus
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top