Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to assign config word in Proteus ?

Status
Not open for further replies.

baileychic

Advanced Member level 3
Joined
Aug 2, 2017
Messages
728
Helped
56
Reputation
112
Reaction score
57
Trophy points
28
Activity points
7,033
How to assign config word in Proteus ?

For PIC16F88 there are 2 Config words shown in mikroC PRO PIC Compiler but Proteus PIC16F88 model has only 1 field for Config word. How to enter config word for PIC16F88 in Proteus ?

See image.
 

Attachments

  • DUNS.png
    DUNS.png
    302.2 KB · Views: 147

You don't need to enter this configuration word. It should be done by Proteus or the compiler you are using. If you have 2 configuration words, that may mean that you have 2 options, but you can set only 1. What settings do each of the configuration words set? Check the datasheet for how many configuration words can be used at 1 time.
You can try by adding 2 bytes "0xByte1 0xByte2".
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top