+ Post New Thread
Results 1 to 3 of 3
  1. #1
    Member level 1
    Points: 354, Level: 4

    Join Date
    Mar 2018
    Posts
    37
    Helped
    0 / 0
    Points
    354
    Level
    4

    Choosing IC with EN signal

    Hi,
    Please help me in choosing the type if IC. My input is 28V DC, if i give an enable signal as 3.3V, then my IC should pass the input voltage i.e 28V as output. I know it can be done using FET. But i have to implement it with IC, I dono what type of IC to choose. Please give me some suggestions.

    •   AltAdvertisement

        
       

  2. #2
    Super Moderator
    Points: 74,693, Level: 66
    Achievements:
    7 years registered
    Awards:
    Most Frequent Poster 3rd Helpful Member

    Join Date
    Apr 2014
    Posts
    15,146
    Helped
    3448 / 3448
    Points
    74,693
    Level
    66

    Re: Choosing IC with EN signal

    Hi,

    Depending on current and voltage drop you may use an
    * analog switch
    * analog multiplexer
    * high side switch

    Klaus
    Please don´t contact me via PM, because there is no time to respond to them. No friend requests. Thank you.



    •   AltAdvertisement

        
       

  3. #3
    Advanced Member level 5
    Points: 9,710, Level: 23
    d123's Avatar
    Join Date
    Jun 2015
    Posts
    1,717
    Helped
    401 / 401
    Points
    9,710
    Level
    23

    Re: Choosing IC with EN signal

    Hi,

    IF the supply is 5V, SN7407 buffer (or similar) is an option, but 30V max. Vout could be an issue, so close to 28V. If the supply available is only 3.3V, not possible with this (old) IC.

    Not that isolation is a requirement, but an optocoupler could be used for this, too.



--[[ ]]--