fparveen
Junior Member level 3
Hello All,
I am simulating a head model in HFSS (driven modal) which has a total volume (rad box volume) of 1648440mm^3 or 1648 cm^3. I am using intel core i5 with 6GB RAM. However, I am unable to reach the end of simulation. Everytime, after almost 3-4 hours or even longer simulation, it fails showing 'solver out of memory'. Does anyone know how can I reduce the mesh density to reduce the simulation time? Or is there is other suggestion that could help me finish the simulation?
Thanks in advance.
I am simulating a head model in HFSS (driven modal) which has a total volume (rad box volume) of 1648440mm^3 or 1648 cm^3. I am using intel core i5 with 6GB RAM. However, I am unable to reach the end of simulation. Everytime, after almost 3-4 hours or even longer simulation, it fails showing 'solver out of memory'. Does anyone know how can I reduce the mesh density to reduce the simulation time? Or is there is other suggestion that could help me finish the simulation?
Thanks in advance.