Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] How to do source and load pull on multi-stage PA?

Status
Not open for further replies.

maxsidou

Member level 1
Joined
Aug 21, 2018
Messages
38
Helped
4
Reputation
8
Reaction score
3
Trophy points
8
Activity points
361
Hello, everyone!
Currently I am learning to design multi-stage PA. In ads, we can simulate the source&load pull on single stage PA. So how to simulate when it comes to multi-stage PA? Or is there any good way to match the multi-stage PA? I'm new to multi-stage PA and expect your any idea. Thank you!
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top