Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Trimming offset voltage

Status
Not open for further replies.

zhorik21

Newbie level 6
Joined
Sep 6, 2017
Messages
12
Helped
1
Reputation
2
Reaction score
1
Trophy points
3
Activity points
91
trim.PNG
I found in book this circuit for trimming offset voltage. Laser cutting is not used for this. How can realise this circuit? I need use extra transistor to switch to supply raill or triming with zener-zapping?
 

Fuse trim is one you can do anywhere (but maybe or maybe not
"production qualified"). Poly or aluminum neck and a bond pad
per "cut" (unless you go to on chip trim switches, which can be
even larger than a bond pad and then you need a programming
-interface- as well).

NVM controlling a switch FET gate is another common option.
Not my fave as in some applications NVM is not nonvolatile, and
you may be pushed onto a more expensive flow to get the EEx
element.

Zener zap and gate zap are also nonvolatile (OTP) options,
can work as a direct element or a gate control.
 
thank for you reply. What is NVM ? How it look like?
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top