easim
Newbie level 4
Hi to all,
I'am designing 1kW push-pull converter. Design specs are below;
60VDC input
20kHz to 100khz operating frequency. ( Fixed but i could change it)
400VDC-2.5A output
I'am looking for analog controllers for this converter. So far i found TL494/TL594 controllers but these voltage mode controller. Is voltage mode control can be a problem for push-pull?
Texas has some current mode controllers like UCC28089 (actually it has lots of). Has anyone ever done this kind of project before? Could you recommend me controller?
Thanks.
I'am designing 1kW push-pull converter. Design specs are below;
60VDC input
20kHz to 100khz operating frequency. ( Fixed but i could change it)
400VDC-2.5A output
I'am looking for analog controllers for this converter. So far i found TL494/TL594 controllers but these voltage mode controller. Is voltage mode control can be a problem for push-pull?
Texas has some current mode controllers like UCC28089 (actually it has lots of). Has anyone ever done this kind of project before? Could you recommend me controller?
Thanks.