+ Post New Thread
Results 1 to 4 of 4
  1. #1
    Member level 2
    Points: 1,257, Level: 8

    Join Date
    Dec 2013
    Posts
    49
    Helped
    0 / 0
    Points
    1,257
    Level
    8

    cmfb - creation cm voltage

    hi
    how can we create in cmfb amplifier circuit a CM voltage?
    explenation that CM voltage is ideal( or desired) common mode output voltage.
    i am reading Gray & Mayer book and in chapter 12 (about cmfb) has been used CM voltage , but in this chapter does not have explained how to create this voltage
    i think with an inverter that its output tied to its input ,maybe can be create desired voltage but the mismatch and thermal effect will change this value.
    thanks

    •   AltAdvertisement

        
       

  2. #2
    Advanced Member level 3
    Points: 5,608, Level: 17
    Dominik Przyborowski's Avatar
    Join Date
    Jun 2013
    Location
    Norway
    Posts
    741
    Helped
    310 / 310
    Points
    5,608
    Level
    17

    Re: cmfb - creation cm voltage

    Before chapter 12 is a chapter 4 in this book. Read it, there is an answer for your question.



    •   AltAdvertisement

        
       

  3. #3
    Full Member level 1
    Points: 1,014, Level: 7
    ashrafsazid's Avatar
    Join Date
    Sep 2016
    Location
    Germany
    Posts
    102
    Helped
    1 / 1
    Points
    1,014
    Level
    7

    Re: cmfb - creation cm voltage

    The CMFB compares between your "output common mode" and "desired common mode" and feeds back a negative signal for regulation. The desired CM voltage you can generate by using a resistive divider from rail-to-rail, assuming your rails are already robust.
    Your life is all about ΔΣ, the narrow you estimate it, the precise it is ...



    •   AltAdvertisement

        
       

  4. #4
    Member level 2
    Points: 1,257, Level: 8

    Join Date
    Dec 2013
    Posts
    49
    Helped
    0 / 0
    Points
    1,257
    Level
    8

    Re: cmfb - creation cm voltage

    hi ashrafsazid
    itis in first glance, but then below problem are raised:
    large area
    power consumtion
    matching thermal effect

    i think can create with inverter that output connected to input, but then thermal effect and mismatch are leaved



--[[ ]]--