Thayne
Member level 3
I have an old, discontinued, Zone Control Module from a former radiant floor heat system that I want to re-purpose for use of the power relay. My plan is to send a signal to the power relay from an ESP32. I have the power relay datasheet and think it will work for my project. I don’t want to desolder the power relay from that circuit board in case I use it later for something else.
Sorry if this is a dumb question… How can I hook the ESP32 to the board and then to an appliance? Is it possible?
Thanks!
Sorry if this is a dumb question… How can I hook the ESP32 to the board and then to an appliance? Is it possible?
Thanks!