Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How To Disable No Load Shutdown function on Prolink UPS

Status
Not open for further replies.
I

indika74

Newbie level 3
Joined
Apr 28, 2014
Messages
3
Helped
0
Reputation
0
Reaction score
1
Trophy points
1
Activity points
20
Dear all,

I have discussed this before also, but I just wanted to share this thing also with you.

It's a ProLink as in the pic. It was a very small thing that has to do, but it took a bit of time to find out. It's only a 33K ohms resistor connection between the +Positive terminal & the point where I connected as in the pic. Hope you can see the way I done. It needs around voltage of 0.3 V to the point of the last relay driving circuit in the board.
 

Attachments

  • WhatsApp Image 2018-11-20 at 12.18.17 AM.jpeg
    WhatsApp Image 2018-11-20 at 12.18.17 AM.jpeg
    104.5 KB · Views: 372
  • WhatsApp Image 2018-11-20 at 12.18.18 AM(1).jpeg
    WhatsApp Image 2018-11-20 at 12.18.18 AM(1).jpeg
    197 KB · Views: 429
  • WhatsApp Image 2018-11-20 at 12.18.18 AM.jpeg
    WhatsApp Image 2018-11-20 at 12.18.18 AM.jpeg
    95.4 KB · Views: 351
  • WhatsApp Image 2018-11-20 at 12.18.19 AM(1).jpeg
    WhatsApp Image 2018-11-20 at 12.18.19 AM(1).jpeg
    175.6 KB · Views: 384
  • WhatsApp Image 2018-11-20 at 12.18.19 AM.jpeg
    WhatsApp Image 2018-11-20 at 12.18.19 AM.jpeg
    214.3 KB · Views: 867
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top