indika74
Newbie level 3
Dear all,
I have discussed this before also, but I just wanted to share this thing also with you.
It's a ProLink as in the pic. It was a very small thing that has to do, but it took a bit of time to find out. It's only a 33K ohms resistor connection between the +Positive terminal & the point where I connected as in the pic. Hope you can see the way I done. It needs around voltage of 0.3 V to the point of the last relay driving circuit in the board.
I have discussed this before also, but I just wanted to share this thing also with you.
It's a ProLink as in the pic. It was a very small thing that has to do, but it took a bit of time to find out. It's only a 33K ohms resistor connection between the +Positive terminal & the point where I connected as in the pic. Hope you can see the way I done. It needs around voltage of 0.3 V to the point of the last relay driving circuit in the board.
Attachments
-
WhatsApp Image 2018-11-20 at 12.18.17 AM.jpeg104.5 KB · Views: 372
-
WhatsApp Image 2018-11-20 at 12.18.18 AM(1).jpeg197 KB · Views: 429
-
WhatsApp Image 2018-11-20 at 12.18.18 AM.jpeg95.4 KB · Views: 351
-
WhatsApp Image 2018-11-20 at 12.18.19 AM(1).jpeg175.6 KB · Views: 384
-
WhatsApp Image 2018-11-20 at 12.18.19 AM.jpeg214.3 KB · Views: 867