Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Provide customized service for video conversion scheme

Status
Not open for further replies.

jaxlee

Newbie level 1
Joined
Jul 6, 2017
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
27
Solution about AHD2.0 converts AV/ VGA/HDMI/ YPBPR

With the development of high definitional camera with analog signal such AHD, TVI and CVI, the traditional AV cameras are replaced. In the past, if a product with rear camera can't support high definition and analog signal, the only way is to change the whole set of terminal equipment. Because it costs a lot, this is a big questionable challenge. However, out solution does solve it! By combining the box of converting AHD2.0 to AV, terminal equipment can accept AHD signal eventually.

Nowadays, there are three solutions about converting AHD or TVI.
1. Connecting with FGPA. It not only has big power dissipation, but also costs more.
2. Using IC from Hisilicon. Perhaps, costing more is not a big deal , but the huge volume may only suit to produce DVD.
3. Using IC from Chipav. It must be a wonderful idea because it is small volume, low cost, and small power dissipation, so this IC (CV2880) is very suitable to produce converters.

This new IC 2880 is ready mass production. If you need any information about this IC, you can just contact with Zhongrong Li

TEl:4155288550
Eamil:jax@chipav.com
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top