Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Glitches at the output of CM driver

Status
Not open for further replies.
R

rty94

Guest
Hello,

Currently I am designing a tx current mode driver .Output has the expected values but there is a problem,I see some glitches at the output that are not desirable. Is there any possible way to fix and smooth my output during time?

Thanks in advance! :smile:
 

Look to your final stage current control scheme. A hard-banging
switched gate will inject Miller spikes on every transition. A
source-current-steering scheme can inject much less. Now if
the glitches appear when the output should be settled, that
is another sort of mystery.
 
  • Like
Reactions: rty94

    R

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top