Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Problem with using XL6009 boost converter

Status
Not open for further replies.

electronicsIUST

Member level 3
Joined
Feb 12, 2017
Messages
67
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Activity points
575
Hello, I want to supply an ATMEGA16 and sim800 module with a 3.7 Li-ion battery, so i used XL6009 module (not IC, figure below) to convert 3.7 to 5V. When just uC is connected to the output of XL6009 everything is ok and output is 5V, but when I connect sim800 module, XL6009's output rises to about 10 Volt!! I even connect the converter module to sim800 module out of PCB and the same problem happened. What can be the problem?!

XL6009-Step-up-DC-Boost-ADJ-Module-4A-02.jpg
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top