Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

To Create Normally Closed Contact with Electronic components.

Status
Not open for further replies.

helex

Junior Member level 1
Joined
May 5, 2014
Messages
18
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
112
Hello Everyone,

I need to design a "Normally Closed" (NC) contact with Electronics components with following load requirements,

Load Voltage = 230 VAC
Load Current = 2 A Max.
Load = AC Motor

please suggest any low cost solution for the same.
 

Hi,

You don't tell anything about the control signal.

I'd use a NO relay, but invert the control signal.

Klaus
 

Hi Klaus,

Thanks for your reply.
Please note that control signal coming from TRIAC, SCR and Microcontroller network.
I don't want to use mechanical relay.
My requirement is that if control circuitry fails because of any reason then my Fan should be kept ON through "Normally Closed" contact.
 

Hi,

I didn't mention a mechanical relay.
I said NC, but I assume this can't fullfil the requirement "when control circuit fails"....

Does "fail" always mean "false OFF" ... isn't "false ON" possible, too?

Klaus
 

Fail means both "false OFF" and "false ON".
Any component of Control Circuit may be "Short" OR "Open" during failure.
 

Hi,

in this case you can´t rely on the control signal. Thus even a NC relay won´t help.

I recommend a second (redundant) control signal. Best if it is from another independent circuit with indpendent source of information.

Klaus
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top