Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

ADM2582E/ADM2587E isolated transceiver layout when shielded with metallic enclosure.

Status
Not open for further replies.

Georgy.Moshkin

Full Member level 5
Joined
Oct 9, 2017
Messages
266
Helped
44
Reputation
88
Reaction score
38
Trophy points
28
Activity points
2,465
Is it possible to avoid recommended layout if whole circuit is placed under metallic shield? And still meet emissions standards (emission levels not greater than original unshielded evaluation board). My device is powered through EMC filters. I only expect unwanted 100MHz and up to leak through RS-485 A/B lines and maybe some gaps between shield and GND1 (logic side).
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top