Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
you can use template based post processing. Assuming you want farfield properties, Just go to Farfield properties> Farfield Result and from there you can select a quick configuration in the list like Directivity,constant Phi =0 etc or you can go to all settings and set it as you like. After that you can do the same for e-field etc aswell.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
