mertberkea
Newbie level 2
Hello friends,
I am a junior d&v engineer at a relatively small company. I assigned for a task that I need to convert an high frequency RF signal into baseband signal.
From my telecommunication lectures I know that I need a carrier wave to obtain low and high frequency components of my original signal. Then if I apply a lowpass filter, only baseband component of my original signal will remain. Please correct me if I am wrong.
All apart from that I need to implement this phenomenon with VHDL. Thank you in advance for all kinds of help for this problem.
I am not asking for a ready-to use code. You can write your experiences or recommend me some books about it too.
Regards
I am a junior d&v engineer at a relatively small company. I assigned for a task that I need to convert an high frequency RF signal into baseband signal.
From my telecommunication lectures I know that I need a carrier wave to obtain low and high frequency components of my original signal. Then if I apply a lowpass filter, only baseband component of my original signal will remain. Please correct me if I am wrong.
All apart from that I need to implement this phenomenon with VHDL. Thank you in advance for all kinds of help for this problem.
I am not asking for a ready-to use code. You can write your experiences or recommend me some books about it too.
Regards