Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[moved] RF PCB trace lift off fixes?

Status
Not open for further replies.
J

jv1

Newbie level 1
Joined
Sep 23, 2018
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
11
[moved] RF PCB trace lift off fixes ?

Hi ,

I was measuring a device on an RF fixture and the part became unstable and blew up. Unfortunately, the RF PCB trace lifted off of the PCB. Is there an easy way to fix it ? Has anyone tried using epoxy or superglue to fix it. I understand that the dielectric constant under the trace might change, but hopefully, not much since it will be used in tiny quantities. Anyone has any insights !

Thanks
 

Re: [moved] RF PCB trace lift off fixes ?

Just stick it back with superglue or epoxy- just remember that superglue can melt with heat (epoxy does not). The change due to the dielectric constant underneath the trace cannot (possibly) be measured and is insignificant.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top