Freestylesoap
Member level 3
Hello,
I am working on EM simulation of transmission lines. For example, a 50ohm transmission line.
What kind of calibration should I use for the input and output ports? Is there any general rules that specify when to use TML or None? For this 50ohm line I am simulating, None or TML calibration gave different results.
Thanks!
I am working on EM simulation of transmission lines. For example, a 50ohm transmission line.
What kind of calibration should I use for the input and output ports? Is there any general rules that specify when to use TML or None? For this 50ohm line I am simulating, None or TML calibration gave different results.
Thanks!