Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Command Line Switches in VCS Makefile

Status
Not open for further replies.

ganesh_bhogaraju

Newbie level 3
Joined
Oct 16, 2007
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,305
Hi All,
May I know:thinker: what are the Flags -bs and -os meant for in VCS Makefile in context of SV UVM Simulations, Unable to find the same after checking the VCS Manuals.

Thanks and Regards,
Ganesh
 

Hi All,
May I know:thinker: what are the Flags -os for command bs meant for in VCS Makefile in context of SV UVM Simulations, Unable to find the same after checking the VCS Manuals. Can you please point out to a document containing explanation for the switches/flags.

Thanks in Advance,
Ganesh

"Can you please point out to a document containing explanation for above mentioned command and the switches/flags"
 

Why don't you read the Synopsys VCS Command Reference Manual?

"Can you please point out to a document containing explanation for above mentioned command and the switches/flags"
Cannot be pointed to because that doc is a copyrighted material.
 

Checked the Manual from google, could not find anything relevant. Will check again from the tool -> help, which in initial attempt is not successful. Its bs command with -os switch.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top