Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
If you are aware of SVRF (Calibre) code then you can use top level Boundary layer as input parameter, use ANGLE command to get the horizontal and vertical edges, report the length of horizontal and vertical edges either by using LENGTH > 0, this would report coordinates of failing edge and then you can measure the difference between coordinates.
EXTENT command givers you a bounding box (rectangle) for the whole design (all layers).
I don't know the command to measure the sides of a rectangle - but this should be pretty basic in SVRF.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.