pragash
Advanced Member level 2
hi all,
I'm supposed to do EM co-simulation. EM co-simulation meaning layout will be simulated first and lumped components will be connected on the same layout. However, when I selected EM Co-simulation, the simulation stops after two 2 second which is not right!
when i selected EM simulation/model instead, simulation runs like how it supposed to be.
i want to simulation the layout, and then import the layout component to the schematic to connect lumped elements and run simulation. which setup type is correct for this simulation. im thinking it should be Em co-simulation but its actually not! anyone know why?
I'm supposed to do EM co-simulation. EM co-simulation meaning layout will be simulated first and lumped components will be connected on the same layout. However, when I selected EM Co-simulation, the simulation stops after two 2 second which is not right!
when i selected EM simulation/model instead, simulation runs like how it supposed to be.
i want to simulation the layout, and then import the layout component to the schematic to connect lumped elements and run simulation. which setup type is correct for this simulation. im thinking it should be Em co-simulation but its actually not! anyone know why?
