Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

CST measurement error (wrong lenght)

Status
Not open for further replies.
B

baby_2

Advanced Member level 4
Joined
Jul 20, 2016
Messages
105
Helped
2
Reputation
4
Reaction score
1
Trophy points
18
Activity points
873
Hi,

Two days a ago a designed a model in CST software with specific which was defined by some variables. However, after setting and removing the face constraint one the shown face, CST measurement made me crazy.As you can see I have set the leng variable 19 which is more than the total length of my outer shape(19>12.08) but before face constraint it worked fine(leng=9 was completely enough and fine but in this scenario it doesn't work properly) .

2.JPG

- - - Updated - - -

Strange:
3.JPG
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top