Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Mosfet Driver - IGBT Driver

Status
Not open for further replies.
D

Dimitrisvlamis

Member level 2
Joined
Dec 12, 2017
Messages
42
Helped
1
Reputation
2
Reaction score
1
Trophy points
8
Activity points
366
Hello, I am planning to make an H bridge for an inverter, and i have these IGBT drivers, can i use them to drive mosfets? My frequency is 15KhZ - 66uS period.

https://www.infineon.com/dgdl/Infin...N.pdf?fileId=db3a30433e30e4bf013e3c649ffd6c8b

In the data sheet it says that min on/off time is 0.8nS for the type i have.(2EDL05I06PF) The only difference i saw, was for the dead time. Which for my version is 380nS.

Do you think it will work with mosfets ?

(Yes i am within voltage range etc)


Thanks in advance.
 

Hi,

Do you think it will work with mosfets ?
Click to expand...
Nobody knows what MOSFET you are talking about.
--> you need to read both datasheets and compare the values.
But generally I´d rather use a driver that is suited for MOSFETs. (I assume there is a good reason why they build different drivers for MOSFETs and IGBTs)

*******
You have a problem with the units:
"15KhZ" --> 15kHz (all uppercase and lowercase reversed)
"66uS" --> 66us (66uS means 66 microSiemens which is the same as 15151Ohms)
"0.8nS" --> 0.8us = 800ns
Try to use the correct units to avoid confusions.

Klaus
 
  • Like
Reactions: burai

    B

    burai

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top