+ Post New Thread
Results 1 to 2 of 2
  1. #1
    Member level 2
    Points: 315, Level: 3

    Join Date
    Dec 2017
    Posts
    42
    Helped
    1 / 1
    Points
    315
    Level
    3

    Mosfet Driver - IGBT Driver

    Hello, I am planning to make an H bridge for an inverter, and i have these IGBT drivers, can i use them to drive mosfets? My frequency is 15KhZ - 66uS period.

    https://www.infineon.com/dgdl/Infine...3e3c649ffd6c8b

    In the data sheet it says that min on/off time is 0.8nS for the type i have.(2EDL05I06PF) The only difference i saw, was for the dead time. Which for my version is 380nS.

    Do you think it will work with mosfets ?

    (Yes i am within voltage range etc)


    Thanks in advance.

    •   AltAdvertisment

        
       

  2. #2
    Super Moderator
    Points: 66,832, Level: 63
    Achievements:
    7 years registered
    Awards:
    Most Frequent Poster 3rd Helpful Member

    Join Date
    Apr 2014
    Posts
    13,637
    Helped
    3121 / 3121
    Points
    66,832
    Level
    63

    Re: Mosfet Driver - IGBT Driver

    Hi,

    Do you think it will work with mosfets ?
    Nobody knows what MOSFET you are talking about.
    --> you need to read both datasheets and compare the values.
    But generally I´d rather use a driver that is suited for MOSFETs. (I assume there is a good reason why they build different drivers for MOSFETs and IGBTs)

    *******
    You have a problem with the units:
    "15KhZ" --> 15kHz (all uppercase and lowercase reversed)
    "66uS" --> 66us (66uS means 66 microSiemens which is the same as 15151Ohms)
    "0.8nS" --> 0.8us = 800ns
    Try to use the correct units to avoid confusions.

    Klaus
    Please don´t contact me via PM, because there is no time to respond to them. No friend requests. Thank you.


    1 members found this post helpful.

--[[ ]]--