lprocha
Newbie level 4
I´m trying to simulate in HFSS a Balun cable , and try to get the same results as i have in Genesys , i alredy test it in real world and Genesys result are very consistent , so i´d like to undestand what im doing wrong in HFSS.
Below is the circuit in Genesys ( it is a line 20mm 75 ohms )
The S paramitters of this circuit ,
Now i prepare a simulation in HFSS using a cable ( calculate the inner and outer to get the same 75 ohms ) and i use a board to do the unbalaced measurment.
This is the ciruit
I already try the terminal and Modal solution and i got the same result, and its very different from Genesys linear simulatio.
could someone give me some idea about it ?
Below is the circuit in Genesys ( it is a line 20mm 75 ohms )
The S paramitters of this circuit ,
Now i prepare a simulation in HFSS using a cable ( calculate the inner and outer to get the same 75 ohms ) and i use a board to do the unbalaced measurment.
This is the ciruit
I already try the terminal and Modal solution and i got the same result, and its very different from Genesys linear simulatio.
could someone give me some idea about it ?