Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Looking for Motor-Please advice

Status
Not open for further replies.

Abhishekabs

Advanced Member level 3
Joined
Jan 12, 2007
Messages
757
Helped
117
Reputation
234
Reaction score
45
Trophy points
1,308
Location
India
Activity points
5,537
Hello,
I am looking for DC motor for making a test set up.
Below are my selection criteria for motor.

Motor Specifications:
1) Motor Type: PMDC Motor
2) Voltage : 24VDC
3) HP: 0.75 to 1HP
4) RPM in loaded condition: 6000RPM ( If you have higher RPM than this, is also acceptable)


I checked with few suppliers but their RPM goes down for loaded condition. Datasheet writes 6K RPM but actually it is 3.5K RPM for loaded condition.
Can anyone recommend me motor for specs mentioned above?

Also are their any low cost, small size three phase PMSM? With same specs mentioned above?
 

Hello,
I am looking for DC motor for making a test set up.
Below are my selection criteria for motor.

Motor Specifications:
1) Motor Type: PMDC Motor
2) Voltage : 24VDC
3) HP: 0.75 to 1HP
4) RPM in loaded condition: 6000RPM ( If you have higher RPM than this, is also acceptable)


I checked with few suppliers but their RPM goes down for loaded condition. Datasheet writes 6K RPM but actually it is 3.5K RPM for loaded condition.
Can anyone recommend me motor for specs mentioned above?

Also are their any low cost, small size three phase PMSM? With same specs mentioned above?

Try ampflow f30-150. You can find them on eBay.
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top