Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I would like to make a layout of a rectenna on ADS. I already generate the Layout through the schematic but i don't know understand how does it work, how to trace line, link elements and modify the diode size (footprint).
Lumped components are used (Murata Library).
Help me please
You should build your schematic with foot prints and proper netlist. Layout just transfers your compnents and Tlines netlist and attached component footprints from your schematic to layout.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.