Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Horn Antenna to coax pin feed

Status
Not open for further replies.
J

jesuschrist

Member level 4
Joined
Feb 9, 2017
Messages
79
Helped
9
Reputation
18
Reaction score
8
Trophy points
8
Activity points
566
Hi. I've designed a waveguide to coax adaptor for an S band feed horn. The thing is when I was designing the conductor that goes into the waveguide I didn't check available product length and took Pasternack's PE4099(Candlestick SMA connector) as base for conductor and ptfe dimensions . Now I see PE4099 has a conductor length of 17.9 mm. I need to use a pin that is 26.47mm long (lambda/4). What should i use for pin feed for this S band Horn, is it ok to use rg402 coax soldered to SMA 4 hole flange ?.

Thanks
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top