Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Mixed SMD and PTH board

Status
Not open for further replies.
T

treez

Guest
We are doing a PCB which has both surface mount components and through hole components on it.
The surface mount components are on both sides of the PCB.
What’s the closest that a surface mount pad can be to a through hole pad?
 

Depends on the soldering technique and used equipment. Most popular is selective wave, needs a certain distance between though-plated pin and SMD components on the bottom side, e.g. 3 - 5 mm. Ask your assembly house.

No restrictions apply for hand soldered components.
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
A FvM already replied. You have to talk with your assembly house. But to give you an idea. I have attached the numbers from our assembly house.


Capture.JPG
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top