Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

hSpice 2016 cosmoscope 2015

Status
Not open for further replies.

akbarza

Full Member level 2
Joined
Dec 18, 2013
Messages
131
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,296
Activity points
2,556
hi
newly i was starting to use hspice 2016 on win 10-64 bit.
after installing hspice 2016, i installed cosmoscope(cscope) version 2.8 release 2015(32 bit) for viewing hspice simulation results, but it doesn't plot correctly. hspice is right, problem related to cosmoscope.
for example for a simple rc low pass filter , the plot must be a curve, but it is not.
i appended the cosmoscope plot for low pass rc circuit.
please guide me thanks.
Capture.PNG
 

hi
I have the same problem too. I tried Custom Waveview 2013 & Avanwaves 2016 but they both don't plot correctly.
Still trying to find solutions but no response.
If you have any progress, please update it one the board, tks!
 

use in hspice below term
.option post=1 OR .option post =2
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top