Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Low pass filter used b/w neutral and ground connection.

Status
Not open for further replies.
A

akashjoseph1997

Newbie level 4
Joined
Nov 10, 2013
Messages
7
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
45
Why did low pass filter used b/w neutral and ground connection.
Since neutral has no charge ,then is it required?

is neutral and ground has 0v,Can we connect capacitor c25 to neutral instead of connected to ground

I am only beginner in this electronics pls help me



te voltage.PNG
 

Read it carefully! It doesn't say 'ground' it says 'AGND'. It isn't ground as in Earth, it's the analog ground of the ADC circuit but it must NEVER be connected to mains wiring Earth or to any other truly grounded point. The circuit has no mains isolation so it should only be used in situations where none of it can be touched and it has no direct external connections, for example in a self-contained electricity meter.

Brian.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top