Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Xilinx SoC Zynq 7020 + Flash problema

Status
Not open for further replies.
F

flote21

Advanced Member level 1
Joined
Jan 22, 2014
Messages
411
Helped
1
Reputation
2
Reaction score
3
Trophy points
1,298
Activity points
5,595
Hello folks,

I have designed a customized PCB board based on the evaluation kit ZC7020 of Xilinx. And I am having issued to run the Flash with the preescaler x2 (maximum speed) in my customized board. The same flash chip and same configuration works perfect in the ZC7020. my customized board only achieves x8 o bigger preescaler configurations. I have already checked signal integrity and it is fine to that speed. I am always read 0x0000.
Anyone knows anything about this?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top