Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to avoid extra region lines after using regrid__silvaco to simulate FETs

Status
Not open for further replies.

Risewisun

Newbie level 1
Joined
Jul 10, 2018
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
5
Extra region lines after regrid__silvaco

Hello, everyone!
I'm learning to use silvaco to simulate FETs. But while I use regrid to make a fine design of the structure, there is always extra region lines in it. Please see the picture. How could I avoid these lines? remesh4-8minc.png
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top