CHETHAN2323
Newbie level 1
My LCVCO is converging .i.e. starting when I am not checking any transient algorithm. In this case, I am getting the required tuning frequency.
But when I turned on gear2 or gear2only algorithm, then my LC is not starting for any vcontrol signal. The oscillations are getting damped.
The same setup when I am doing transient simulation without checking algorithm in transient options, then my LCVCO is working perfectly.
Is it necessary that it shoul work with gear2 or gear2only algorithm?
What might be the reason for this ?
Can anyone please help me out with this?
But when I turned on gear2 or gear2only algorithm, then my LC is not starting for any vcontrol signal. The oscillations are getting damped.
The same setup when I am doing transient simulation without checking algorithm in transient options, then my LCVCO is working perfectly.
Is it necessary that it shoul work with gear2 or gear2only algorithm?
What might be the reason for this ?
Can anyone please help me out with this?