Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Orcad heterogeneous part issue

Status
Not open for further replies.
welove8051

welove8051

Full Member level 6
Joined
Jul 16, 2009
Messages
357
Helped
51
Reputation
102
Reaction score
41
Trophy points
1,308
Location
india
Activity points
3,277
Hi, how to add other heterogeneous part for a part like relay in orcad cadence, if you want to add later. for example the DPDT relay has 3 parts namely coil, NONC1 and NONC2. i prefer to add coil part now in schematic and NONC1( L13A) and NONC2(L13B) part later. my question is how to invoke the NONC1( L13A) and NONC2(L13B)part of previously added coil part?

with respect to the uploaded image, i want to add L13A and L13B of the relay.



thanks
 

Attachments

  • relay.PNG
    relay.PNG
    31.5 KB · Views: 90

I haven't used Orcad in a while, but what you're suggesting doesn't make much sense. You've created a part with a single sub-part and now you want it to be have three sub-parts. That's a whole new part. You can modify your original part in the library, but you can't just arbitrarily add sub-parts to the schematic and make them part of the original one.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top