Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Interfacing Raspberry Pi with Keithley 3390

Status
Not open for further replies.
J

john1998

Newbie level 6
Joined
Jun 8, 2018
Messages
12
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
152
I wanted to interface Rpi with the function generator Keithley 3390. My goal is to capture the signal which Keithley 3390 generates and plot it using Rpi, i.e, to function it as an oscilloscope. I went through the reference manual of Keithley 3390 but could not come up with a solution. Please help.
 

Hi,

There is no question.

First you need to know which interface (hardware) you need.
Then build this interface.
Then you need to know which interface parameters you need to use.
Then you need to know the protocol.

So go step by step.
Ask a detailed question. What help do you need. Don't ask global questions.
Give more informations. Where did you look for informations, what documents do you refer to, what did you understand, and what did you not understand.

Klaus
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top