Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Active fresnel reflectarray in cst mws. What conditions must be set to obtain the correct response?

Status
Not open for further replies.
B

bikrader

Newbie level 4
Joined
Feb 14, 2016
Messages
7
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
67
Good day. I began to study Active fresnel reflectarray in cst mws and decided to try to repeat the results from paper " New Antenna for Millimetre Wave Radar". However, I can't get the same result. What conditions must be set to obtain the correct result? Any additional information I will send you by mail. Thank you very much in advance.
The application contains:
  • My and others' S11 parameters
  • Sizes
  • Picture for explanation of sizes
  • And the model.
 

Attachments

  • S11arg.PNG
    S11arg.PNG
    35.6 KB · Views: 60
  • s11argmy.PNG
    s11argmy.PNG
    120.9 KB · Views: 59
  • s11mag.PNG
    s11mag.PNG
    27.9 KB · Views: 58
  • s11magmy.PNG
    s11magmy.PNG
    46.9 KB · Views: 63
  • sizes1.PNG
    sizes1.PNG
    27 KB · Views: 64
  • sizes2.PNG
    sizes2.PNG
    28.5 KB · Views: 72
  • sizesexp.PNG
    sizesexp.PNG
    151.2 KB · Views: 65
  • reflectarray.zip
    16.3 KB · Views: 49

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top