+ Post New Thread
Results 1 to 3 of 3
  1. #1
    Newbie level 3
    Points: 588, Level: 5

    Join Date
    May 2015
    Posts
    4
    Helped
    0 / 0
    Points
    588
    Level
    5

    Mutliple power sources

    Hello,

    I am designing a circuit where there is a need of different power sources
    3.3V(for micro SD card level shifter),
    5V(micro controller unit),
    15V (Fet Drivers).
    Is there any way(any circuit or any idea to develop one) so that we can reduce the no. of power sources in the overall design?

    Thank you.

  2. #2
    Super Moderator
    Points: 60,116, Level: 59
    Achievements:
    7 years registered
    Awards:
    Most Frequent Poster 3rd Helpful Member

    Join Date
    Apr 2014
    Posts
    12,276
    Helped
    2840 / 2840
    Points
    60,116
    Level
    59

    Re: Mutliple power sources

    Hi,

    so that we can reduce the no. of power sources in the overall design?
    I dont understand. If you need three supply voltages you need to generate them.

    Either you need 3.3V or not.
    If you need it you will have to generate this 3.3V.
    You may use
    * Linear regulators (reducing voltage only)
    * step down switching with inductor
    * step up switching with inductor
    * capacitive switching

    You may use a flyback topology with multiple output voltages.

    Or you use a ready to buy supply.
    Doesn´t an ATX PC power supply generate all three voltages? (Just saw it generates 12V instead of 15V, but maybe also good for a FET driver)

    Another idea: using FETs which can be driven from 5V.

    Klaus
    Please don´t contact me via PM, because there is no time to respond to them. No friend requests. Thank you.



  3. #3
    Advanced Member level 4
    Points: 7,115, Level: 20

    Join Date
    Jun 2015
    Posts
    1,254
    Helped
    295 / 295
    Points
    7,115
    Level
    20

    Re: Mutliple power sources

    Hi,

    Odious obvious remark: It would help to know what the supply(ies)/source(s) will be. Without that information, maybe a dual LDO, and I'm certain that 5V and 3.3V are abundant as those are such standard voltages. The Fet driver, maybe a switcher, as Klaus already said (and feed the dual LDO from it's filtered output...).



--[[ ]]--