ktr
Full Member level 3
Hello all,
I have a problem of importing a dxf file of a filter into ADS layout. I designed a hair-pin filter in another Cad program, and exported its dxf file. When I try importing it into ADS however, ADS does not understand it as a component but random shapes :bang:.
I need to make Em simulations and get its s-parameters so I can model it as a n-port device with those s-parameters and put it into a bigger simulation.
When I try importing it and try setting up EM simulation I get error messages of "Bounding area mask 4 contains no shapes." and "Port setup needed to be corrected."
1- I am using ADS2016 as my software, designed the filters in HFSS 16.0.
Thanks and Regards.
I have a problem of importing a dxf file of a filter into ADS layout. I designed a hair-pin filter in another Cad program, and exported its dxf file. When I try importing it into ADS however, ADS does not understand it as a component but random shapes :bang:.
I need to make Em simulations and get its s-parameters so I can model it as a n-port device with those s-parameters and put it into a bigger simulation.
When I try importing it and try setting up EM simulation I get error messages of "Bounding area mask 4 contains no shapes." and "Port setup needed to be corrected."
1- I am using ADS2016 as my software, designed the filters in HFSS 16.0.
Thanks and Regards.