sakibnaz
Full Member level 3
Hi All.
My project is a Load Charging Device. Load can be a Smartphone or Tablet. In my system I want to monitor if the Load is In-Charging or Fully-Charged.
I am thinking to do it by monitoring the current of the Charging line. To do that is there any suitable dedicated IC? Or how about to put a low Ohm resistor (R-Sense) into the Charging line and measure Voltage across it to get the current value then determine the status of Charging?
Please advice whats the best approach to do this design.
Thanks in advance.
Regards.
My project is a Load Charging Device. Load can be a Smartphone or Tablet. In my system I want to monitor if the Load is In-Charging or Fully-Charged.
I am thinking to do it by monitoring the current of the Charging line. To do that is there any suitable dedicated IC? Or how about to put a low Ohm resistor (R-Sense) into the Charging line and measure Voltage across it to get the current value then determine the status of Charging?
Please advice whats the best approach to do this design.
Thanks in advance.
Regards.