Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

iip3 for diff mixer using ads

Status
Not open for further replies.

samaneh_mahmoudian

Newbie level 5
Joined
Feb 21, 2018
Messages
8
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
49
hi , could you help me, how i can simulate iip3 for a diffrential mixer?
 

hi , could you help me, how i can simulate iip3 for a diffrential mixer?
There are six terminals(RFinp, RFinm, LOinp, LOinm, IFinp, IFinm)
So there are 36 characteristics regarding both physical ports and driving schemes(Diffrential and Common).

What characteristics do you have to evaluate ?

If only simple diff-diff-diff characteristics is required, use ideal balun for RF, LO and IF.

https://www.designers-guide.org/Analysis/diff-sp.pdf
https://www.designers-guide.org/Analysis/diff.pdf
 
Last edited:

Thanx for your attention...
I used 3 baluns for (LO,RF,IF)
But I have a problem for simulate ... in display window the result has a lot of distortion for fundamental and 3-order Vif.

1.jpg

2.jpg

3.jpg

- - - Updated - - -

Thank you so much...It is a gilbert cell mixrer...I used 3 balun for LO,RF and IF ...but I have a problem in simulation...the result of fundamental and 3-order of Vif is not good..it has got distortion

4.jpg
 

I couldn't understand 3 tones for mixer.How i should write ipo_lower and ipo_upper for mixer? could you tell me?
 


the result of fundamental and 3-order of Vif is not good..it has got distortion
It's not a distortion, your Mixer is simply not working.Have you set-up properly HB controller ?? RF Frequency,LO Frequency and IF Frequency ??
I think something is missing in HB controller.
 

I checked it...it was wrong...I gave my answer ...thank u a lot!
 

iip2 measurment in diff mixer using ads

hi...
could u help me, how can i simulate iip2 for a diff mixer by ads?
Thanx
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top