Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Microcontroller Bus Readers

Status
Not open for further replies.
R

Rocketman46

Member level 3
Joined
Jan 9, 2014
Messages
57
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,859
Hi,

I am looking to buy a new bus reader for decoding I2C, SPI, CAN and I/O signals. I have seen two products:

1) Saleae Pro 8

2) Digital Discovery 2

Does anybody have any feedback on these products, or would you recommend using another product?

Look forward to your reply.

Rocketman46.
 

hello,


i am using a IKALOGIC ScanaQuad Logic Analyzer SQ50 4 channel Logic analyser ..
works fine .. very satisfied to debug I2C protocol or UART

but Now, i think it is better to choose the 8 channel Model SQ200 , even with eigher cost ..
example: for NRF24L01 protocole or more complicated protocole


4 Channels are enough to observe serial protocols like I2C, USART, SPI, 1-Wire, RS485, and most serial communication protocols.
Click to expand...
 

I am very satisfied with Saleae Pro 8. I am using it since more than 1 year. I have tried it for decoding many protocols and it works fine.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top