Puppet123
Full Member level 6
I have a question regarding how to EM simulate mim caps.
I want to see the effect of the bottom plate capacitance to ground in the path underneath my component.
It is a mm-wave amplifier design but in general I can use it for analog design as well.
I want to check the model components from the kit.
How would I go about this ?
I am using Cadence/ADS flow.
Thanks.
I want to see the effect of the bottom plate capacitance to ground in the path underneath my component.
It is a mm-wave amplifier design but in general I can use it for analog design as well.
I want to check the model components from the kit.
How would I go about this ?
I am using Cadence/ADS flow.
Thanks.