Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[CST MW] Need help about bowtie antenna simulation in CST MW

Status
Not open for further replies.

nthhut

Newbie level 1
Joined
May 8, 2018
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
9
Hello,
I have problem when tried to simulate the bowtie antenna.
My purpose is the S(1,1) and the impedance of antenna.
But the result seem incorrect.
Please help me to find out the incorrect point.
Thank you all!

Below is the dimension of bow-tie antenna:
L = lambda/2 = 38mm (f = 2.2GHz)
W = 11.5 mm
I've used discrete port to feed (Please refer the image attached). bowtie_antenna_S11.PNGbow-tie_antenna.PNG
 

discrete port should give good results. is the port placed at the center of the phase?
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top