electronicsengineertry
Newbie level 1
Dear All,
I have been working on switching ON/OFF two devices using Traic which are opto-triac driven.
So far ON/OFF is working fine. My schematic is as attached.
The problem is when I switch ON Lamp 1 - and keep Lamp 2 OFF , still I get (120V between Line and Neutral)
If I switch OFF Lamp 1 - the voltage goes off.
Can you please suggest what I might have missed?
I have been working on switching ON/OFF two devices using Traic which are opto-triac driven.
So far ON/OFF is working fine. My schematic is as attached.
The problem is when I switch ON Lamp 1 - and keep Lamp 2 OFF , still I get (120V between Line and Neutral)
If I switch OFF Lamp 1 - the voltage goes off.
Can you please suggest what I might have missed?
Last edited by a moderator: