Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Re Flow Oven temperature and time

Status
Not open for further replies.
E

expertengr

Guest
We have re-flow oven which has preheating temperature C1 and preheating time T1. Similarly, C2 and T2 is for actual re-flow. I am wondering how to setup temperature-time profile for SMD components, no component is especial. These components can be soldered with normal Sn63 solder paste. The re-flow oven can go up to 260 C.

How the following profile look like ?

C1: 150 C
T1: 240 sec (4 min)

C2: 260 C
T2: 240 sec (4 min)
 

"expertengr"? Pretty pretentious name.

I'm not an expert, but your profile will depend on a LOT of things. What components are you soldering? How densely are they populated? What are the PCB characteristics? And I think your 4 minutes of reflow time is excessive.
 
  • Like
Reactions: d123

    d123

    Points: 2
    Helpful Answer Positive Rating
Assumption: There is no critical component on the PCB. How about the following settings ?

C1: 150 C
T1: 150 sec (2.5 min)

C2: 260 C
T2: 180 sec (3 min)
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top