Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to do tran simulation when invoking SP parameter file

Status
Not open for further replies.

wjj

Newbie level 4
Joined
May 3, 2018
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
36
388616099.jpg1291551971.jpg

When I invoke SP parameter file to do tran simulation.Just as the picture shows,parameter is set in this way,and n2port is connected in this way.So,is there any error? any other setting needed?
Thank you:grin:
 
Last edited by a moderator:

When I invoke SP parameter file to do tran simulation.
Show us simulator name and its version which you use.

any other setting needed?
It depends on method for treatment S-parameter in transient analysis and frequency range and frequency resolution of S-parameter.

Major treatments are convolution and rational model approximation.

Also it depends on maximum frequency or fastest rise time in transient analysis.

https://edadocs.software.keysight.c...leshooting+a+Transient-Convolution+Simulation
https://www.edaboard.com/showthread.php?303606
 
Last edited:

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top