Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

circular waveguide TE11 mode

Status
Not open for further replies.
G

Guruditya Sinha

Junior Member level 2
Joined
Jan 11, 2011
Messages
24
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Activity points
1,473
Hi,

What is the selection criteria behind the length of a circular waveguide, while designing for TE11 mode? Most design handbooks/calculators do not delve deep into the selectivity criterion for length of the circular waveguide.
Any rules of thumb would be helpful!
 

circular waveguide...as in a transmission line? I would keep it under a kilometer or two!

As a RESONATOR...i would not go more than 2 or 3 half wavelengths in length, since the resonance will get very narrow.
 

Length doesn't matter if you are going to use it as just a guide to your horn antenna etc.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top